Integrated amplifier - Luxman - L-590 aX mark 2

Price:  on request

Availability: on request

The L-590 aX mark 2 draws upon Luxman’s decades of experience in amplifier design to deliver an exquisite combination of rich sonic expression, fine detail, wide bandwidth and dynamic gusto. Stereo output is rated at 30W per channel into 8Ω and 60W per channel into 4Ω.

In order to achieve this level of power without sonic compromise, Luxman has implemented its ODNF 4.0 drive circuit utilizing a THREE-parallel push-pull structure with three-stage Darlington. A Luxman ‘Ultimate Efficiency Power Transformer’—an EI type rated at 615VA forms the heart of the amp’s power supply, with plentiful regulation ensuring an unshakable response to any load fluctuations. A high-capacity block capacitor contributes to the L-590AXII’s ability to deliver lashings of power instantaneously yet remain firmly in control, while the amp’s low-impedance transmission design, carefully selected custom components and short, fully optimized signal paths deliver maximum sonic purity.

Compared to the L-590AX, which had only 4 block capacitors, the L-590AX MarkII has 8 in total—4 each L and R. Thus the L-590AX mk 2 has the same configuration as Luxman’s M-700u. Similarly whereas the L-590AX I had 4 output boards, the L-590AX II has 8 output boards. The L-590AX II can now drive even more difficult speaker loads with ease.

Rated output 30W + 30W (8Ω), 60W + 60W (4Ω)
Input sensitivity/input impedance PHONO (MM): 2.5mV/47kΩ
PHONO (MC): 0.3mV/100Ω
LINE: 180mV/47kΩ
BAL.LINE: 180mV/55kΩ
MAIN-IN: 550mV/47kΩ
Output voltage RECOUT: 180mV, PRE OUT: 1V
Frequency response PHONO: 20Hz to 20kHz (±0.5dB)
LINE: 20Hz to 100kHz (+0, ±3.0dB)
Total harmonic distortion 0.005% or less (8Ω, 1kHz)
0.02% or less (8Ω, 20Hz to 20kHz)
S/N ratio (IHF-A) PHONO (MM): 91dB or more,PHONO (MC): 75dB or more
LINE: 107dB or more
Volume adjustment New LECUA1000
Amplification circuit ODNF 4.0
Output configuration Bipolar 3-parallel push-pull
Damping factor 320
Max. amount of tone control BASS: ±8dB at 100Hz
TREBLE: ±8dB at 10kHz
Power supply 230V~(50Hz) / 115V~(60Hz)
Power consumption 330W
260W (under no signal), 0.5W (at standby)
External dimensions 440(W) x 193(H) x 463(D) mm
front side knob of 20mm and rear side terminal of 37mm included in depth
Net weight 28.4kg (main unit)
Accessories Remote controller (RA-17A)
Power cable
Speaker terminal Supported Y-lug terminal dimension Width of part a: 16mm or less
Width of part b: 7mm or more
* Connection may not be performed 
depending on the shape of the 
Y-lug terminal.

Send inquiry